Cat6 connector mainly used RJ45 connector and RJ45 connector is commomly used for networking cabling and telephony application.RJ-11 connector is smaller than RJ-45 connector. But no matter which one you use, it is reassuring to know that both category 5 and category 6 UTP cables have a solid reputation for providing high quality data transmission to local networks around the globe.
Cat6 connector diagram helps to make network connection between ethernet port and a hub or switch or router.although the speces are different from CAT3 and CAT5,CAT6 cables look nearly identical to the others.Inside cat6 cable will be four copper wires ,twisted together.these are generally madeup of 23 gauge wire,although is not required,some instances be made with either 22 or 24 awg(American wire gauge) wire .The main requirement is that the cable meets testing standards which have been set for it.
Cat6 is used as a patch cables for 8p8c connectors.this often leads to confusion, with people referring to them as RJ45 connectors .some cat6 cables which are too large to connect to 8p8c connectors without a specific modular piece.the performance of the cable's signal path will be reduced to the performance of the lower wire category.CAT6 is available in different sizes, with the maximum size currently available being 30 feet (one hundred meters). Cat6 is more costly than thre other ethernet cables,but it give more speed data transfer and closely double bandwidth capabilities of the cat5 and cat5e.
There are CAT6 connectors diagram available which are made specifically to meet certain higher standards than other similar cables meet. As a result, they are able to assist in noise reduction--decreasing the noise typically caused by crosstalk and system interference.
To make sure new installations are done properly and within code, they are usually tested with a qualification tester, validator, or cable certifier. The cat6 network cable is more advanced than the previously used cat5, but not quite as advanced as the cat6a or cat7.